C-12 Quick Release Clamp - Installation Instructions
1/4” Threaded Stud |
Step 1: Thread the Brass Bushing into the central hole of the C-12 from the bottom surface of the clamp. A penny or similar sized coin can be used as an installation tool. Make sure the bushing is fully seated and not protruding. |
||
Step 2: Screw the C-12 onto the Ball Head’s threaded stud. Screw it on as tightly as you can (lock the ball head down and give it some muscle). . |
||
Step 2: Tighten the 3 set screws snugly, using the enclosed 2.5mm hex key (see note below If you are attaching to a cork/rubber coated surface). Note: If the platform you are attaching the C-12 to is fully coated with cork or rubber, so that the set screws are not engaging a metal surface, tighten only the set screw farthest from the clamp’s moving jaw. This will force the bottom edge of the clamp into full contact with the rubber/cork coated platform and create a more robust connection. You can remove the two set screws that you are not using. |
||
|
© Copyright 2020 - Wimberley, Inc. - All Rights Reserved
Made in USA and Assembled in Charlottesville, VA |