C-12 Quick Release Clamp - Installation Instructions
M3 Threaded Holes (qty. 3) |
Step 1: Remove the three small set screws from the center of the Clamp (use the provided 2.5mm hex key). |
||
Step 2: From the bottom surface of the clamp, thread the Brass Bushing into central hole of the C-12. A penny or similar sized coin can be used as an installation tool. NOTE: Make sure the bushing is fully installed and is not protruding. The purpose of the bushing is to keep the bubble level from falling out of the stem. . |
||
Step 3: Attach the C-12 to the ball stem using the three M3 screws and tighten with the 2.5mm hex key. Lightly tighten all three, then go back and firmly tighten each one. There should be a piece of foam in the stem’s central hole; do not remove it! Its purpose is to keep the stem’s bubble level from rattling around. |
||
|
© Copyright 2020 - Wimberley, Inc. - All Rights Reserved
Made in USA and Assembled in Charlottesville, VA |