Back to Previous Page
C-12 Installation Instructions: Giottos M-H 3000

 

Removing the Existing Clamp:   

Unscrew the mounting platform by hand. Removal complete.    

Installing the C-12:   

Screw the Brass Bushing into the threaded hole in the stem of the head (use a penny or similar sized coin as an installation tool). Screw the bushing in fully. It should be flush with the top surface of the stem (or slightly recessed). Fasten the clamp to the head with the 1/4-20 fastener. Use the enclosed 5/32 Hex key to tighten the screw very snugly (lock down the ball head and give it some muscle). Tighten the three set screws firmly using the 2.5mm hex key.  

C-12 Installed:   


      © Copyright 2017 - Wimberley, Inc. - All Rights Reserved                                         Made in USA and Assembled in Charlottesville, VA 

  View Cart 

  Follow Us! 

  Email List