Installing the C-12:
|Screw the Brass Bushing into the threaded hole in the stem of the head (use a penny or similar sized coin as an installation tool). Screw the bushing in fully. It should be flush with the top surface of the stem (or slightly recessed).
||Fasten the clamp to the head with the 1/4-20 fastener. Use the enclosed 5/32 Hex key to tighten the screw very snugly (lock down the ball head and give it some muscle).||Tighten the three set screws firmly using the 2.5mm hex key.|
© Copyright 2017 - Wimberley, Inc. - All Rights Reserved
Made in USA and Assembled in Charlottesville, VA