Installing the C-12:
|Screw the Brass Bushing into the threaded hole in the stem of the head (use a penny or similar sized coin as an installation tool). Screw the bushing in fully. It should be flush with the top surface of the stem (or slightly recessed). If it protrudes, it should stick out no more than the thickness of two business cards (.025").
||Seat the clamp on the stem of the ball head. Make sure the raised key on the stem of the head is seated in the recessed slot on the bottom of the Clamp.||Fasten the clamp to the ball head using the enclosed M6 fastener. Use the enclosed 5/32 Hex key to tighten the screw very snugly (lock down the ball head and give it some muscle).||Tighten the three set screws firmly using the 2.5mm hex key.|
© Copyright 2017 - Wimberley, Inc. - All Rights Reserved
Made in USA and Assembled in Charlottesville, VA