Back to Previous Page
C-12 Installation Instructions: Manfrotto 468MG

 

Removing the Existing Clamp:   
Use a butter knife or similar tool to pry off the layer of rubber on the surface of the mounting platform. Loosen the four screws using a 3mm hex key. Loosen the smaller black screw using a 2.5mm hex key.
 Remove the clamp's central fastener using the enclosed 5/32 hex key.

Installing the C-12:   
Fasten the clamp to the ball head using the enclosed M6 Screw. Tighten the three set screws firmly using the 2.5mm hex key.  

C-12 Installed:   

© Copyright 2011 - Wimberley, Inc. - All Rights Reserved

  View Cart  items -